[BUG] Mutating block and layer states

Discuss about Blockout II from Jean-Luc, post your feature requests etc.
Post Reply
meer
Posts: 1
Joined: Mon Jul 18, 2016 5:37 pm

[BUG] Mutating block and layer states

Post by meer »

I often encounter misbehavior of BlockOut. I did not found any possibility to debug. So, I tried practice mode to make screenshots (see below).

Before step x (first screenshot) the blue layer is already complete, however, it is not removed.

In step x the green layer is being completed.

In step x+1 (second screenshot)
  • the blue layer was removed;
  • the green layer is now blue; it should be removed too, however, one block is missing again (see red arrow).
Used version is 2.5-5.fc23 (on Fedora 23).
BlockOut2.5-StepX-small.png
BlockOut2.5-StepX-small.png (203.24 KiB) Viewed 8405 times
BlockOut2.5-StepX+1-small.png
BlockOut2.5-StepX+1-small.png (202.2 KiB) Viewed 8405 times
Post Reply